and before anyone says anything like...shoulda got a k24....STFU! lol....if i wanted a k24, i woulda got one lol....i like the rev's!
so as many of u might kno, i can be quite indecisive....had a turbo'd a3, had some issues. swapped that out for an a2. went built head with stage I cams, then stage II. my timing chain snapped with the stage II's, thanks skunk2 lol. i then got my head rebuilt with the same skunk2 proseries valve train but with k20z3 cams makin 222whp and 158wtq with the mods in my sig. but when i say indecisive, im talkin about how i bout a s/c for my a2, never put it on and then sold it, pieced together a custom turbo kit, sold than without ever putting it on lol. so yea, a lil indecisive to say the least....oo and im on exhaust No. 10 haha.....so its hard to keep me happy, but i think i may of finally found something that will keep me happy. a fully built a2 that i can safely rev to 9k and perhaps a lil more
here is my plan:
a2 crank (have)
a2 block (have)
eagle h beam rods with ARP bolts (have)
cp 12.5:1 cr pistons
ACL race bearings
ARP head studs
brian crower stage II cams
type-r lsd (hopefully)
type-r final drive
exedy flywheel
(already have, clutch net stage II clutch)
then my current setup
here are some sneak peak pics on what i have already:
the block is in atlanta, chunky has another bare a2 block which i am using....
7-30-2008: ARP headstuds came in
this should all be done and get installed right around xmas....i will keep this thread updated as new parts come in...
Last edited by shadowmd; 07-30-2008 at 03:24 PM.
and before anyone says anything like...shoulda got a k24....STFU! lol....if i wanted a k24, i woulda got one lol....i like the rev's!
That's funny sam, bout what u said bout the k24! lol that's some super-compressed super high revvin beast! don't like the stage 3 cams?
Last edited by jeffgeezer; 07-24-2008 at 06:21 PM.
9k!! Your car will be so fun! And a pretty damn fast N/A car too!!
good luck sam. can't wait to see what your build turns into.
EPHATCH.COM 4 LYFE!! OFF THA CHAIN KREW #1
udontknowjack's mom was here....twice!
UPDATED SITE INFO!
Want to become a Site Sponsor? Click Here!
PM for HELP!!
i'm still holding out for the, "I changed my mind again thread", haha.
Sam, good luck with this build.
hah yea....u can hold off all u want! cause its not coming....this is FO REAL!
thanks guys.....like i said, i will update with pics when parts come in
thanks man.....i will be sure to make some VIDS! haha j/p
Cracked rotor needs to be changed, then vids
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks