The De-Rice project

[Honda_boy83]

[BeaterEP]

Goddamn man, you're going to town on that sucker!

Keep up the good work sir, and then you can come to Texas and help me get my car fixed up

I'll buy you beeeeeeerrrrr ...

[mr-alternative]

@ Gargola

So you got now the problem that you couldnt remove this ball jointed bolt which fixes knuckle with the wheel ball joint housing?

I have got the same problem at the passengers side when I was changing some rubber by using a "joint set". Of course it wasnt the outer one, so i need to take out th ewhole driveshaft.

So i have got the same problem as you.

I solved it by:

Using some ball joint tool like you have pictured at first in your last post. I turn it it was strong enough. If everything fits exact vertical this tool works fine.
But as it was at my and your Ep it wasnt.

So I tooked some WD 40 at first, wait some minutes, and then using some 5 kgs. sledgehammer and put with it some 2-3 strong strokes at the knuckle. Finally the combination of this tool and sledgehamer worked for disconnect it.

I hope this may helps you.

[brian1414]

This is such an epic thread!!!!
subscribed!!!

[Draw7Seven]

This is such an epic thread!!!!
subscribed!!!

You, uh... you do know the thread hasn't been posted in for over 4 years, right?