TSX head, cams
K24 accord bottom end
TSX internals (pistons and stuff)
Kpro, tsx base map
Finished the swap, engine turned over. Ran like crap, but it ran.

Did a compression test but I didn't warm up the engine first so the numbers were a wash.

After the test I put the spark plugs back, coils, connect wires back, and now it doesn't start. The longest I could get it to run is a few seconds then it dies. Any further attempts right after just flood it. You can see beads of gas (at least I hope it's gas) sitting on the piston and the spark plugs are drenched after trying to start - all cylinders.

Took valve cover off, chain hasn't skipped teeth. Replaced the spark plugs, checked all sensors to make sure they're connected, same results.

Starter works, it's turning the engine over but it doesn't seem to fire. No fuses are blown.

Ideas?