Here is the backside of the platform with the excess foam trimmed off
And the topside
The foam will need to cure a little longer inside(it got cold last night in the garage) and then I will add the exterior S-glass and then get everything mounted.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
Ok got a bit more done now that I got some more Epoxy Resin. The foam side recieved 3 layers, E-glas/Kevlar/E-glas, the top recieved 3 layers, E-glas/Cf/E-glas
I didnt think having an exposed layer of CF around all those amps was a good idea, and why it is top layered with E-Glas
Top view, battery, 100 amp breaker, hot 12vdc distribution block, Cap, switched power block w/relay
Side view, notice the bottom profile
This will be then glued/bolted to the chassis under the amp rack. I will have a total of 10 additional available circuits, 4 hot and 6 switched +12vdc.
Last edited by talonXracer; 10-23-2010 at 12:39 PM.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
Bookmarks