does the jdm dipstick from the K20A3 fit in the K24A2 ? the reason I ask is because I was told it was short
does the jdm dipstick from the K20A3 fit in the K24A2 ? the reason I ask is because I was told it was short
i took the dipstick out of my a3 and using it in my k24a2....fits fine
LOL, the K24 dip stick is 19mm longer due to a 19mm taller deck height.
How in the hell are you checking your oil level?
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
Definatley a difference in the length.
Black one is K20 and the orange is K24
so i can tell ppl with black dipsticks that my dipstick is longer X)
it shows full on the stick, but it takes 6 L to fill now. lol
na, idk it took 4.5 to fill it up and it was at the top dot on the stick, although now that i think about it i believe i did swap the dipsticks because the ep3 one was black
Last edited by RHCP0801; 11-17-2010 at 06:37 PM.
You better start on the memory training now then! Dont wait till you forget like me....LOL
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
how much oil would a frank build need, the same as a tsx motor?
yea, every motor is gonna be a bit different though so just fill up to the top dot on the dipstick. My tsx motor takes 5.5
Dont paint it, dye it. It wont chip off either. I did a DIY on it a while back.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks