Yes you can run Boost by gear, you just need a hondata, aem, or mac boost solenoid. Once you have one of these solenoids you can control it in kpro.
was wondering if its possible to run a setup like this with kpro? i haven't seen anything on it here on the forums, but it looks like some of the flashpro guys are using it.
Yes you can run Boost by gear, you just need a hondata, aem, or mac boost solenoid. Once you have one of these solenoids you can control it in kpro.
yeah i was just seeing that. crazy how you can just get a mac solenoid for $20. i found everything i need so far except where to connect the wires...
Yeah the hondata solenoid is a mac solenoid, hondata just puts their name on it. Although I have done some reading that says the duty cycle on the hondata/mac solenoids are different and may have been recalibrated by hondata, I haven't been able to confirm that yet. If you get a hondata solenoid it will come with instructions to install it telling you where to pin it into your ecu harness. Using the mac you are left searching for a wiring diagram.
Tony.. why didnt u just ask me lol... i had BBG on my setup
cause you wasn't on. LOL.
I found the wire to splice into, but now I forgot. I wanna say it was yellow with a blue stripe. I'll go find it.
Found it:
http://forums.clubrsx.com/showthread.php?t=305579
where is the brown connector? under steering wheel?
Last edited by AKEP; 01-30-2011 at 06:28 AM.
i did the yellow blue wire on the one goin to the ECU.. and the wire on the ignition column.. for power
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks