hubs and rotor should be it, when i did mine my toe bolt in the rear was a PAIN IN THE ASS... i tried to loosen the blot and it seized up on me, so i just cut it and replaced a new one
hi guys im about to buy some ep3 05 hub and rotors to make my 4 lugs to 5 ! what other part I would need?
hubs and rotor should be it, when i did mine my toe bolt in the rear was a PAIN IN THE ASS... i tried to loosen the blot and it seized up on me, so i just cut it and replaced a new one
And axles.
If you get parts from an 02-04 rsx type s you can reuse your brake lines and and sensors. If not you'll need much more.
And yeah your rear bolts on the trailing arms will more then likely freeze so use lots of pb blaster and heat.
Good luck
The TS stated he was procuring new EP3 parts to change to 5 lug, and not DC5S conversion.....no need for axles or anything else..........And why would he have to do anything with the trailing arm that requires you to even look at it's bolts let alone need to remove them, even doing a typeS swap?!?
TS, you may consider a set of bearings as well, removing and reinstalling used bearings usually impacts their longeviety significantly. Do not forget your spare tire will now be useless, snag a spare from a junked DC5/late EP3.
Last edited by talonXracer; 04-29-2011 at 05:46 AM.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
Whoooops, my mistake. I never even consider that route
Just curious whats the cheapest/ easiest route with out a press?
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks