Hi everyone,
So i have a bit of an issue.
I installed an Omni Power Clutch Master Cylinder a few months back, it has been working. Recently i blew the line from the new Omnipower CMC... I am going to see if i can call omnipower and get another, but before i waste any of my time etc, i need to know if goodridge or anyone else makes a line that replaces that piece. or that replaces the entire section up the OEM brakeline tubing that connects to the slave.
Attached is a picture of the carnage..not sure how it happened..very odd. It was a little chilly out today (7 degrees) pumped the clutch a few times and then wammo..to the floor.
Link me up.
be jealous :P
I know this probably no use to you, but just in case you change your mind. K-Tuned stainless steel braided line is a full length line from CMC to slave and it's under $100. I bought it when I bought the Omni CMC.
Sucks to hear that happen bro, hopefully it's a faulty unit from Omni.
Last edited by USAF EP3; 01-17-2012 at 07:39 PM.
it is a faulty unit, i saw that. it was 96$ :(
be jealous :P
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
Bookmarks