Finally, the semester is over. It is time to do my car audio, those speakers in my living room are begging to be installed.

So I went to West Marine shop to buy some Fiberglass Material and resins. I bought:

1. West System 105 Resin
2. West System 206 Slow Hardener.
3. Mini Pump Sets, Brush and Fiberglass ribbon or mat.

Total $80.00

What I did:

1. Use paper to trace the shape of the bottom. I use MDF for this purpose.
2. Cut the MDF according to your tracing paper. Always cut bigger and trim later, I was almost 1" off.
3. Use Aluminum Foil and Masking tape to cover the panel. Start from bottom to top, so the resin will drip inside the foil.
4. Mix the resin and hardener, apply it as the first layer.
5. Apply the Fiberglass then soak it with resin using the brush. Thicker is better, since you will have at least .5 to .75 in thick of fiberglass.
6. I apply 2-3 layers of fiberglass and now waiting for it to cure.

That's all I have done for today. I will keep posting for updates.

NOTE: This is my first time, I just want to share :)