I did this about a week ago and i haven't seen a diy, so i thought I'd make one.
This is my first diy, so go easy on me
you will need:
8 wire taps
electrical tape
a really small screwdriver
2 sockets p# 33304-S30-003
2 bulbs p# 33303-S30-003
2 connectors p#04321-SH2-307
8 pigtails p# 04320-SP0-A00 or p#04320-SP0-B00
(I had a couple extra connectors and terminals, but you can go to the dealer and have them match it up)
the brake/turn socket will transfer over with no problem. you will need to remove the connector from the top marker light and tap it to the reverse wire
Remove the terminals from the top marker light
you will need a really small screwdriver to lift the lock in the connector and remove the terminal
add terminals to the connector you removed
and to the connector for the new socket
Tap the new connector wires into the top marker light wires (it doesn't matter which way you tap the wires)
Tap the the connector you reused into the reverse light wires (it doesn't matter which way you tap the wires)
Everything should look like this
Electrical tape all the wires separately so they wont short out
and then install into your new (or should i say old) tail lights
Do the other side and you're done
hope this helps out all the people that want to do this. if i left out anything out please tell me.
Bookmarks