Not about the turbo build. But where did u Mount the rear diffuser and front splitter. I want to do both. I also have a lower front h brace. Can the splitter work with it?
Car: 2004 Honda Civic Si
Tuner: Brain @ Speedlab.net
Power Goal: 600hp
Fuel: e85
Drivetrain: 5spd ep3 tranny, LSD, CompCLutch SS
Turbo: PTE 6266 .82 ar
Target boost: 20+psi
Managenment: Hondata Kpro
Lubricants: BradPenn / AMS oil
Aftermarket Goods:
K-TUNED-AFH-KARCEPTS-GOLDENEAGLE-ARP-ID
PRECISION TURBO-FABWORX-HPT-JE
EAGLE-ACL-AEM-HONDATA-COMPETITIONCLUTCH-TIAL-BREMBO-VIBRANT-RUSSELL
INNOVATIVE MOUNTS-WALBRO-AEROMOTIVE-DOWNSTARINC
The narrative that no one cares about:
This build will be started due to the failure of a rod bearing issue, motor was still salvageable, wish I could say the same for the crank.
Will not be doing a crazy build or nun like that, simple and clean, no need to blow 10k.
So with that being said subscribe, check back frequently and feel free to give input, and/or criticism. Sit back and enjoy my work.
Last edited by monjarassi; 10-29-2013 at 07:33 PM.
Not about the turbo build. But where did u Mount the rear diffuser and front splitter. I want to do both. I also have a lower front h brace. Can the splitter work with it?
Last edited by Princess; 05-08-2009 at 02:26 PM.
Sorry my new build doesnt attract u!!
Butt yea the brace wont work with it unless u ghetto rig it and just mount the splitter to your lip/bumper and it wont hold worth n eventually break.
The rear diffuser mounts to the rear bumper and the tray bolts to the gas tank straps.
Nice to see your back at it. But why rebuild the Z3? A stock k20a2 can handle 600+whp and they are plentiful. You could be up and running by the end of the week.
Gotcha. I love your turbo build.lol your car is one of my favorites. I was just curious on the diff and splitter at that moment.lol
Soon after the teardown I made my decision to go through with the build, brainstormed with my tuner on what setup would suit my goal in power level and started searching for the parts I needed. Came across a deal I couldnt refuse!!
JE 86.5mm pistons 10:5:1 compression ratio
JE wristpins
Eagle H-beam rods ARP rodbolts
ACL STD thrust washers
looks like Im going to have to stick around for this...
New set of updates will approach when we reach 20 posts
What's the rev limiter going to be set at for this bad boy
A lil peep glimpse of what im working with this weekend!!
Because RaeKar?
Adios to all the unnecessary stuff!!!
Last edited by monjarassi; 10-19-2013 at 04:54 PM.
You have my attention.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks