What paint? Heat resistant?
Oh yeah! I primed it this time and added three coats
It's acrylic lacquer gloss black. Works great and I also used it on my calipers with no issues. It works very well on plastic but you need to put primer down first for mental surfaces
Test fitted the intake today with some interesting findings. The gear selector is no issue here, there is more than enough room for that.(see pic)
On another note the frame tabs could be notched in a tad to make more room for the filter. But sadly I don't think the fender liner will work with this intake cause it sits very close to the tire. Once I notch the frame tabs 2" there should be some more breathing room. Not ready to install just yet I'm still waiting on my extended battery wires from chase bays and I need a new radiator hose to allow the extra room for the Big ass intake.
Let me buy your pwjdm intake!
Is that test fit on your a3 manifold? If so it sits 3 inches lower than the rbc... So fitment issues... Caused me to run a sri
There are currently 2 users browsing this thread. (0 members and 2 guests)
Bookmarks