DIY: Disable pushing in clutch for startup

[AKEP]

couldn't we just disconnect the connecter and put a wire in it to jump it. instead of cutting the wire?

[ep3 604]

are there any side effects to this diy?

[gehjl]

Only if u forget your car in gear.

[davisj3537]

couldn't we just disconnect the connecter and put a wire in it to jump it. instead of cutting the wire?

Yeah prob...but how hard is it to reconnect the wire after it has been cut...Pretty damn easy sir.

[SpAdZ]

thinking about doing this when i do my next clutch...i run my TT everytime i park so i am always in neutral

[ep3 604]

is it best to do this on an aftermarket clutch or is stock okay too?

[davisj3537]

is it best to do this on an aftermarket clutch or is stock okay too?

There is really no point to do it on a stock clutch. Only the more drastic pressure plates need this modificatin from my understanding. Personally I would do it with anything over a stage 1 clutch but that is just me. I reccomend anyone with an act clutch or comparable to do it regardless of the stage. They have such aggressive pressure plates...

[Jpax]

You guys are some Lazy SOB to do this mod. I can see it used for remote start and maybe someone lives in alaska, but lawl!

Good write up though! Think I might do this to the FIT. LOL

[davisj3537]

You guys are some Lazy SOB to do this mod. I can see it used for remote start and maybe someone lives in alaska, but lawl!

Good write up though! Think I might do this to the FIT. LOL

You didn't read the thread did you? Thrust bearings need our help with heavy pressure plates sir.