Just got my rev hard kit!

[playap07]

Also get a oil pan cutter its a razor blade with a spot you can tap with a hammer. Don't use a screw driver to pry it.

oooooo hahaha i was using a spackle at first and then moved to a screw driver to pry it lol whoops. humm i might have to go to advance auto or somethin now huh!

[playap07]

well I'm done for the day! couple issues were brought up but that's only with my car and my skills.

issue #1 I got a bold stuck in my oil pan


solution.....I'm going to grind that bolt down to the stem and just slide the oil pan off! any objections or suggestions?

issue #2 the bolts holding the headers to the i think the fame are tight as fuck!


solution....i sprayed some w40 on it so hopefully tomorrow they will be a lil bit easier to loosen!

issue #3 is the same as #2 but the header bolts are tight as hell to the block! wasn't strong enough to get them loose!



solution.....dw40.....hopefully it will be a lot easier to loosen tomorrow


Pic of engine bay!


pic of work area hahah junky!



hopefully tomorrow i will get the headers and oil pan off and install the turbo and inter-cooler. Thanks for staying tuned in for that latest in the rev hard chronicles

[civictype_r04]

For the bolts get a breaker bar for them it will make it a lot easier.

[playap07]

For the bolts get a breaker bar for them it will make it a lot easier.

will do! thanks!

[sayayin]

If you leave nearvy I would help you, oh by the way take your time and put a rugh on the down pipe because a nut or something else could go down and then you have to take all your piping to get it out almost hapen to me

[playap07]

roger! thanks 4 the info i will put that to use!

[Guardian]

solution.....I'm going to grind that bolt down to the stem and just slide the oil pan off! any objections or suggestions?

i said it like twice dont grind that bolt off or you will have to tap the block.
they have tools to take off striped bolts

[jeenyusss]

get the fire going

[grindin gears]

my garage looks the same way right now. im using a k24 though so im swapping as well. iv come to problems myself so this is going slow. and usually with the exhaust i always snap the bolts and buy new ones.

[grindin gears]

and yes get a striped bolt removing kit they are like what 20 bucks at ace. drilling the block is not worth it!!!

[playap07]

i said it like twice dont grind that bolt off or you will have to tap the block.
they have tools to take off striped bolts

alright im not going to grind it. thanks for the advice! im a lil bit hard headed sometimes.

and yes get a striped bolt removing kit they are like what 20 bucks at ace. drilling the block is not worth it!!!

ill go to ace and see if they have a striped bolt removing kit! thanks

[playap07]

get the fire going

did you heat wrap before you put the turbo in or after? did you heat wrap evey wire thats back there? what should i heat wrap?

[playap07]

also do you have to relocate the battery??

[bdooley]

i would heat wrap mostly every wire back there cant be too safe. also try using pb blaster or liquid wrench on those header bolts and a breaker bar.

[jeenyusss]

i went crazy wrapping wires, you can never be 2 safe, it gets hot ass hell back there man, go nuts, buy extra if u have 2