Upclose pics of USDM CTR kit - PIC Request

[TezGari]

Dear all,

Searched and can not find upclose pics of the side skirts of the USDM CTR kit.

Can someone pls post pics (esp of the sides, where the screws are) would be happy to see them b4 installing.

I will gladly take pics before/after my install to share with everyone..

Many thanks,

[FoReVaPmP]

Dear all,

Searched and can not find upclose pics of the side skirts of the USDM CTR kit.

Can someone pls post pics (esp of the sides, where the screws are) would be happy to see them b4 installing.

I will gladly take pics before/after my install to share with everyone..

Many thanks,

Soooo, you've already bought the kit?......


I'd just check out the members rides section, there are a few members that have the USDM CTR lip kit on their ride....

[TezGari]

Soooo, you've already bought the kit?......


I'd just check out the members rides section, there are a few members that have the USDM CTR lip kit on their ride....

trueee but the thing is that no one up close pics of the sitting/screws

[charles]

I just have one srew in the front and two in the back. And it has been holding for like two years.

[TezGari]

wow u did a good job on those USDM sides...

I just bought glue, and like 18 screws to test out...But thanks for the pics.
I can see that the rear actually clips on to the little metal part...many thanks.

[15000rpms]

piece of shit! My sides were hard to fit on and I actually broke the side skirt piece that holds the top screw in the front. My rear lip won't line up, and heck, I didn't even try on the mugen lip yet.

Also, do you have any gaps at all, even if it's just a little?

[charles]

piece of shit! My sides were hard to fit on and I actually broke the side skirt piece that holds the top screw in the front. My rear lip won't line up, and heck, I didn't even try on the mugen lip yet.

Also, do you have any gaps at all, even if it's just a little?

yeah i have some gap issues and there is like a crack on one of the skirts because it was really tight. You can try sanding and test fitting over and over until your happy.