this problem just got even worse for me too ahh i need a solution
i have this noise also. its embarrassing.
Ed~
this problem just got even worse for me too ahh i need a solution
i had the same problem i just took out the bottom dash and sprayed a whole lot of wd-40 and never came back :] ehehe
Mine does that every other day, I have learned to live with it.
I used white lithium grease on mine. It goes away for a while, then I spray a lil more in and it's gone.
I brought mine into the dealership for the same thing about a year ago and they replaced the master cylinder for the clutch. I was under the extended warranty at that point. Haven't had the noise since.
This is NOT a recall, it is only listed under the service bulletins.
NOPE this is a very common occurance. There is NO SPRING that parallels the CMC pushrod shaft.
The issue is that the pushrod end is a simple rounded off rod, this end rides within the end of the CMC's piston in a cup recess. This joint comes with NO LUBRICATION, what happens is over time the pushrod end develops a point and this digs in wearing it out even more, causing a screech and a click. If you replace the CMC, you must apply some grease into the end of the CMC to keep this from happening again.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
if i dont treat the problem will there be a bigger problem.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks