immobilizer?
so i bought k pro from a guy who had a k20a2 and and installed it in the car which still has a k20a3.... all i did i was plug the k pro to see if it would work.... it did and now the i the car doest crank over.... i uploaded the factory PNF kal. still doesnt wana crank..... i put my stock PNF ecu bak in and it starts right up....... is it the ecu??? help... any sugguestions???
To elaborate:
Try turning off the immobilizer.
it ran for 10 mins and then the car shut off and it cranks but wont start..
load a k20a3 cal up and it should work
did you load a base rsx or si k20a3 map? they are a little different.
the only thing that would stop it from cranking are a wrong map or the immobilizer is enabled. its not going to hurt to double check and reload a new map. it takes all of 30 seconds mang
when ever i load a new map it takes a few cranks to turn over...... like 3-5 seconds
and the immobilizer box should be unchecked
and to load it make sure the lighting bolt is clicked on the top and then i use "ctrl + U" to up load the map. i usually do it three or four times as well
Last edited by thisisagame24; 06-15-2010 at 03:42 PM.
no problem d00d ..... glad we got it working
thisisagame is one sexy mammajamma
Green Crew #7
Please donate and support EPHatch.com: Greenie Status, License Plate Frames, Banner & Small 'ephatch.com' Decals
Was your WTS/WTT/WTB closed? Please read the following: link 1 & link 2
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks