I have had the heater section disconnected for years now, never had an issue all the way down to -10 degrees F as a DD.
cleaning didnt work for me so I bought a new one and received it yesterday and will install this weekend when I do my coolant flush.
I have had the heater section disconnected for years now, never had an issue all the way down to -10 degrees F as a DD.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
I Just got mines today... CANT WAIT to get it in after work and reset the idle. $258 was a lot for this little part though. :-(
HAHA!... Yeah... I've seen that, but I needed one ASAP before something worse happened to my car. Honda had it in QUICK... Car is running excellent now. But Im still haveing an Idle problem where it stays up at 1,500 and wont go down. I think I need another idle reset. I did it twice yestarday and both times it got better and better, "Third times a charm" as they say. AND WHO ARE "THEY".... ???? LOL
did you do the proper idle relearn procedure?
Ed~
The proper procedure is to get the engine to operating temp, reset the ECU and keep the RPM's to 3K for 3 Minutes time, adding any time the fans are on to the three minutes.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
I might pick up a set of these if I'm gonna have to be cleaning this out as often as you say.
http://www.amazon.com/Silverhill-Poi.../dp/B002P4YCGM
Did this today. Awesome DIY writeup and not too hard at all. Took about 2 hours to take it all apart and clean it.... bout 20 min to put it all back together. Idle is back to normal and car runs super sweet now. Thanks!!!
bump.. just cleaned it again and runs good again... this time it only took me an hour total!... last time was like 3 hours to take off, clean and put back together...
yeah man.. i can help... it's pretty ez.. the only other tool that you really need is the dremel to take off the screw or u can just get that tool from ebay.. we'll worth the mod bro..
sidenote: I almost bought a new IAC but good thing I didnt....haha
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks