It can be made to fit, the mount near the filter needs to be "tweaked"
alright so i can get my hands on an Injen Cold Air Intake for an RSX-S and i wanted to know if i could get this sucker to fit on my ep3...but i have an a3 still
if not oh well :/
It can be made to fit, the mount near the filter needs to be "tweaked"
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
Good intake too. Better than my aem soda straw my engine breathes thru.
Last edited by ErikDELUXE; 01-25-2010 at 01:50 PM.
I love my Injen MR cold air intake.
I had to use a combination of cable ties and a coat hanger with a little creativity to hold it on. It was meant for a temporary solution but i haven't figured out what to do in place of that.
Also, make extra sure that the counterweight on your shift linkage will clear the intake through all of the gears. I had to cut some plastic from my radiator fan shroud with a dremel to get a fitting angle.
I had an Injen CAI, and I hated it. It sat to close to the ground and the air filter was soaked every time it rained. Even with a Hydroshield it didn't matter. I would never buy another one.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks