Just looking for information because this is going to be the next step for my car in the next 2 months.
Please help meh!
What can be reused and what do I need to replace?!
ugh HT. that's one place I haven't looked. Guess that's my next stop. Hopefully it's detailed.
found it, wow is it seriously this easy??....he even took the motor out through the top. WOW! lol.
Here's the link.
http://www.honda-tech.com/showthread.php?t=2410236
So according to that, I re-use my idler pulley inplace of the PSP
use the EP serpentine belt
EP shift linkage and axles
race header + kpro
Last edited by 02TWSI; 10-05-2010 at 08:30 PM.
Its pretty dang easy.. just a quick run down.
1. get kpro.. if not you will have to get the dc5 ecu and have honda reprogram your key. Or buy the imobilizer by pass. Either way kpro will be best.
2. use ep3 wiring harness
3. use ep3 axles
4. some cars need the shifter notched to reach reverse, some don't. Mine didn't.
5. GET KPRO.
What exhaust set up are you going to use?
Dump the power steering pump and swap over the idler pulley, follow the Helms manual for removal and replacement of the stock engine, plus swapping of ECU's(or Kpro) and a possibility of needing modification of the shifter to get into reverse.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
I knew i forgot something.. idle pulley, which means you will have to get a smaller size serpenten belt.
Nice so since I'm getting kpro, already have BCSS, and also have a2 guts in my 5 speed case I'll be golden. Do i need any RSX hoses ? Where can I get a K20A2 long block w/ legit papers and a good bill of health?
I'm going to be running an EP specific RH and catback. Most likely a KRRH and a BuddyClub ProSpec.
Last edited by 02TWSI; 10-05-2010 at 08:43 PM.
Nope... from what i remember hoses and everything else is a direct swap. Sorry dont know where to buy a legit a2..
Thanks dude. appreciate the help all...
as a general rule of thumb, what are you guys replacing maintenance wise before swapping in the "fresh" motor....oil, filter, what else?
I steamcleaned the exterior of the engine, then checked/adjusted the valves, change oil/filter and plugs.
With the smaller dia A2 crank pulley, EP3 idler pulley with EP3 serp belt, the belt tensioner will be past the point of belt replacement. The fix for this is to add 2-3 washers between the alternator and block at each of the three mounting bolts. This will take up the excess serp belt perfectly and ensure you dont have any issues.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
I see, is there any belts out there that fit snug and wouldn't require a diy fix?
swapping a k20a2 is just that easy, i'd have to say the hardest and most boring part of the swap was cleaning up and putting tools away.
but i always hate doing those things haha
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks