Wow, you had to do some modifications to make it work. But good thing you knew what you were doing. Mine was a good fitment, had no issues.
I can't tell you the diameter of the midpipe off the top of my head but I have been running a Greddy Ti-C catback for the past few years.
As a note on the earlier mentioned occasional rattle I would experience, it has been fixed:
-The primary o2 bung was pointed more upwards than most pictures I have seen posted by members that are running an OBXRH V.2. I had to cut a small piece of the heat shield out which eliminated part of the rattle problem.
-Installing this header moved my midpipe closer to the car to where it was barely kissing part of the edge of the frame. A couple of loving whacks with a hammer to where the midpipe was touching solved this problem eliminating any rattling issues.
The problem with the midpipe touching the car may have been unique to my header(such as the primary O2 sensor placement screw up) or it may be that my catback/header combo drew it too close to the frame.
Either way, for what the header cost....I'm not crying about it.
Wow, you had to do some modifications to make it work. But good thing you knew what you were doing. Mine was a good fitment, had no issues.
I've had mine in for about 3 weeks now, no issues at all, cleared the sway bar fine, it is pretty close but I have ESMM's so it probably doesn't hit because of those
Hey all, I ran these headers for about 5 months already and it still good.
When i got it, it was already heat wrap also. It was noticeable whenever I open the hood, it wasn't as hot as before.
As well I bought these from a guy that did a k24a2 swap and he ran these headers.
I still needa get that o2 slim. Been lazy lol
I've had mine for like 3 years, I enjoy it. One day I'll wrap it
It really was not as bad as it sounds, but still an inconvenience.
I have not seen anyone else with the same fitment issues.
Yeah i think you are the only one. The other issue from other people is that it is hitting their stock front sway bar but mine clear completely on the stock front sway bar.
Would an 05 type s midpipe fit wit my obx headers?
After doing my emissions check, I'm strongly considering the obx race header.
Quick question for you guys, what kind of defoulers are you guys using and where did you get it from?
Let me know thanks!
You guys should Check out this race header you could get a good deal from him a little more expensive than the obx but better quality lemme know what you think
http://cgi.ebay.com/ebaymotors/ws/eB...#ht_5910wt_760
Anyone know if the obx v2 is still available? And where i can buy?
Might have to be my next purchase....good info here.....
can you run a RH without k-pro? any downsides doing this?
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks