So I recieved a used valve cover from an RSX type S. (I believe)
And I noticed that it seems to have an extra bolt on it, that my current k20a3 valve cover doesn't have.
I heard all the K's were interchangeable so I was wondering what do I do with this hole?
And is this the only difference between the valve covers?
WTS: 17" beater wheels 4 lug, Dell Studio 1555 Laptop, Volvo Lip, Nikon mount lenses, BuddyClub wing, and more. PM me.
http://www.ephatch.com/forum/showthr...110#post935110
^this
all the k20/24 valve covers are interchangeable. there are sight differences. honda ones will say 'honda' and acura ones will say 'honda motor co'. also between k20/24 covers, some will have threaded studs that hold the spc and some will have bolt holes. also, i know some VC's have an extra bolt hole on the driver's side, side of the VC. also, sometimes the nipple for the breather valve is different. but in the end, what marc says is true. they are interchangeable.
and and with the hole, you don't have to do anything. you can use it as a ground point for a ground kit, maybe? bling it up with a mugen bolt?.. i dunno lol
Green Crew #7
Please donate and support EPHatch.com: Greenie Status, License Plate Frames, Banner & Small 'ephatch.com' Decals
Was your WTS/WTT/WTB closed? Please read the following: link 1 & link 2
Drove with my parking break on about half a mile, I was pushing the gas pedal all the way and realized my car wasn't going past 40. That's when i looked over and my E brake light was on. I quickly put it down and drove home. Did I just damaged my car?
Probably your e-brake pads? Or just plain old pads in the rear if I'm correct.
I wouldn't say it's broken but it probably got thinner.
You can't cause any serious damage doing that. I'm sure you just wore a tiny bit of your rear brake pad away..
The absolute worse thing that could happen (still I couldn't imagine it happening- unless you drove like that for an hour) would be a warped rear rotor or 2...
You're fine dude. You'll know when your rear pads are shot and if you bent a rotor.
@nmy - thanks for the reply man , I got worried last night.
Will a short shifter assembly like the BuddyClub short shifter fit in both the RSX and the ep3?
How much of an over kill with the BCSS and a short shift adapter like the Neuspeed be? haha
WTS: 17" beater wheels 4 lug, Dell Studio 1555 Laptop, Volvo Lip, Nikon mount lenses, BuddyClub wing, and more. PM me.
http://www.ephatch.com/forum/showthr...110#post935110
WTS: 17" beater wheels 4 lug, Dell Studio 1555 Laptop, Volvo Lip, Nikon mount lenses, BuddyClub wing, and more. PM me.
http://www.ephatch.com/forum/showthr...110#post935110
I saw a REVO brand short shifter labeled "for 01-05 RSX/CIVIC" a while back
Is there any truth to this or no?
The picture showed a short shifter assembly, not an adapter.
WTS: 17" beater wheels 4 lug, Dell Studio 1555 Laptop, Volvo Lip, Nikon mount lenses, BuddyClub wing, and more. PM me.
http://www.ephatch.com/forum/showthr...110#post935110
There are currently 2 users browsing this thread. (0 members and 2 guests)
Bookmarks