idc how low a dyno reads, stg 2 cams on a k24a2 should be 250+ esp from yosolo. either that or your motor is seriously hurt.
yea yosolo tunes aggresive. 2 of my my freinds took there boosted k's to em, both ended up blowing. And a ephatcher has a horror story on here about them. His a2 turbo blew up while they were tuning it
Last edited by superchargedk20; 12-28-2012 at 07:48 PM.
Good call Q. Its not so much the combustion chambers, even though there is a difference there, its the runner design. The k24a2 head works best with its longer runner manifold to produce TQ and midrange. The k24a2 head flows less than the k20a2 head, and the k24a1 head flows the best up to 7krpm. The BC stg2 cams would work better with his RBC and either a k20a2 or k24a1 head. Or... reinstall the k24a2 cams for the k24a2 head and the RBC... and retune (of course).
If the BC stg2 profiles are the same as when i had them... then he might do better going with a PRC mani over the RBC too. It depends though... i didnt have an RBC to test back then. The TQ curve looks a little weak from 3 to 6krpm... could be cam angle or the fact the tuner didnt do a lot of work with ignition advance. Its hard to say.
yea k20s are putting out that much but swapping at k20a2 head on it would definitely make a difference. tuning it on a 100 degree day doesn't help either.
Bookmarks