do you have or plan to have fog lights?
I'm moving my battery to my trunk and need to know where I should run 4 gauge wire through the firewall. Thanks!
do you have or plan to have fog lights?
Made with bits of real panther, so you know it's good.
There is a hole in the driver side fender is suposed to be used by fog lights. If you don't have fogs and don't want fogs, you could run it there. I think thats what he wanted to say ;)
yep, it's the easiest spot.
Made with bits of real panther, so you know it's good.
I ran my amp power thru there THEN decided I wanted fogs and had to drill out a new hole.... MOTHER OF PEARL was that a pain in the ass. FYI, there's a LOT of metal in that part of the car.
Made with bits of real panther, so you know it's good.
There are a few plugs under the dash on (my) left side.
First remove the plastic part there the Hood-opener is, then you see a few plugs
You also do have to remove the Fusecover thingy to reach the plug.
they are white plugs, remove 1 top one.. then to get on the outside.
go to the left front wheel, and remove the mudflap thingy, starting from the Front door, by taking out the pressfit connectors.
you only need to do this about half way, about 7 pressfits, and at the bottom part at the Skirt there's 3 screws.
when those are out you can push the mudflap thingy away from you, peek to the right and you should be able to see the place where you removed the plug.
for getting cables to your enginebay/front, lay the cables on top of the mudflap, towards your left headlight. then when the cables are tightend up you can start putting the mudflap back to its position.
From there it should be easier ;)
Thanks everyone. I just bought fogs too so it's good to know what you guys said about that.
I put my battery in the trunk spare tire housing I drilled out a large hole in the front part of the housing and put in a rubber grommet. I ran the battery cable through the hole, over the gas tank, and along the fuel/electrical lines under the car. They pop out right at the fuse box under the hood where the original cables attach. Place another ground from neg to the chassis in the trunk. Running wires from trunk inside the vehicle is a bit harder.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks